Starting out as someone’s “Living room home decoration”, this 1976 440ci engine was bored .030″ and fitted with a 4.15″ stroke crank. – 496ci stroker engine build with 8/71 Kühl Roots supercharger – 4.15″ stroke [more … ]
Needed to make a pulley for the alternator and powersteering belt to run on on the blowermotor project. I had a nice chunk of aluminium laying around so I went to work on the lathe [more … ]
Started working on my next stroker motor project. Below is a mockup of the crank and the aluminium maincaps. Some minor clearancing needs to be done in the block for the rod-bolts to clear the [more … ]
The block has been machined. The following machinings have be done: – Decking; – .030″ Overbore; – Cylinder honing; – Line-bore; – 2.5″ Concrete fill in the waterjackets. The 440Source.com 4.15″ stroker crank has gotten [more … ]
Copyright © 2024 | WordPress Theme by MH Themes
